Close

904.269.0202

inc. 24-hr emergency

DIY Replace Shallow Well Jet Pump

DIY Replace Shallow Well Jet Pump


Removing Old Jet Pump

Step 1 Shut off Electric from Electrical Panel

Step 2 Isolate/ Shut off Water to the House/Building

Step 3 Disconnect Electrical Wires connected to Switch

Step 4 Disconnet Suction Line from the Head of the Pump.

* Tip: Make sure to have Bucket or Tub to catch water

Step 5 Disconnect Water Line going to the Pressure end of the Pump

Step 6 Remove Schraeder Vale to Release Vaccum

Step 7 Open Valve to Drain tank until it empties


Wooo... Now that we got that out of the way it is time to put in your New Shallow Jet Pump . If you don't have one yet check out our selection HERE

Step 1 Check existing Water Connections for any serious alignment issues with New Jet Pump

Step 2 Install Existing Pipe into the Bladder tank of the New Pump

Step 3 Install new Mounting Bracket to Bladder Tank

Step 4 Mount New Shallow Well Jet Pump to Bladder Tank

Step 5 Wrap Telflon Tape around Brass Bushing 3 times for Suction

Step 6 Reinstall Fiited Piping to the Jet Pump Head

Step 7 Reinstall Fitted Piping to Pressure Side of Pump

Step 8 Set pump Electrical Requirements

Step 9 Use Teflon tap to wrap secure pipes together

Step 10 Reconnect Jet Pump to Water Piping

Step 11 Reconnect Electrical Supply

Step 12 Check for Operation and Leaks

Leave your comment